Ares Chronos FP 110 Manuel d'instructions télécharger pdf (Page 10)

• When transporng or temporarily storing the baery, the

temperature range should be from approximately 40–100°F.

Do not store the baery or model in a hot garage, car or

direct sunlight whenever possible. If stored in a hot garage or

car the baery can be damaged or even catch re.

• Do not over-discharge the LiPo baery. Discharging the

LiPo baery too low can cause damage to the baery

resulng in reduced power, ight duraon or failure of the

baery enrely.

• LiPo cells should not be discharged to below 3.0V each

under load. In the case of the 1-Cell/1S 3.7V LiPo baery

used to power the Chronos FP 110, you will not want to allow

the baery to fall below 3.0V during ight.

• The 4-in-1 control unit has low voltage cuto (LVC)

protecon. When the ight baery voltage drops below a

set point the LED will begin to blink rapidly and the throle

gradually is reduced. At this point the baery is at about 3.4V

and should be recharged.

Charging LiPo Battery

You must charge the included 150mAh 1-Cell/1S 3.7V 25C

LiPo Baery (AZSH2273) using only the charge port on the

rear of the Transmier, the oponal USB charger (AZSH2294)

or a suitably compable LiPo baery charger. Charging the

LiPo baery using a non-LiPo baery compable charger

(such as a NiCd or NiMH baery charger), or even a dierent

LiPo baery charger with the incorrect sengs, may result

in damage to the baery or even re resulng in property

damage and/or personal injury.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Ares Chronos FP 110 Manuel d'instructions Page 10